Alcatel 9000 Guía de usuario descargar pdf (Pagina 59)

100

101

Configuring Ethernet Ports Setting Combo Ethernet Port Parameters on OmniSwitch 6800 and 6850 Switches

OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006 page 1-23

Note. Please refer to “Autonegotiation Guidelines” on page 1-7 for guidelines on configuring autonegotia-

tion.

Configuring Crossover Settings for Combo Ports

To configure crossover settings on a single combo port, a range of combo ports, or all combo ports in an

entire slot, use the interfaces hybrid crossover command. If autonegotiation is disabled, auto MDIX,

auto speed, and auto duplex are not accepted.

Note. In the interface hybrid crossover command, the copper keyword is used to configure the copper

RJ-45 10/100/1000 port while the fiber keyword is used to configure the fiber MiniGBIC SFP port.

Setting the crossover configuration to auto will configure the interface or interfaces to automatically

detect crossover settings. Setting crossover configuration to mdix will configure the interface or inter-

faces for MDIX (Media Dependent Interface with Crossover), which is the standard for hubs and switches.

Setting crossover to mdi will configure the interface or interfaces for MDI (Media Dependent Interface),

which is the standard for end stations. And setting the crossover configuration to disable will disable

crossover configuration on an interface or interfaces.

To configure crossover settings for all combo ports on an entire switch, enter interfaces, followed by the

slot number, hybrid, either fiber or copper, crossover, and the desired setting. For example, to set the

crossover configuration to auto on for all copper combo ports slot 2, enter:

-> interfaces 2 hybrid copper crossover auto

Note. using the interface hybrid crossover command to set all combo ports on a switch will not affect

the configurations of the non combo ports.

To configure crossover settings on a single combo port, enter interfaces, followed by the slot number, a

slash (/), the combo port number, hybrid, either fiber or copper, crossover, and the desired setting. For

example, to set the crossover configuration to auto on copper combo port 47 on slot 2, enter:

-> interfaces 2/47 hybrid copper crossover auto

To configure crossover settings on a range of combo ports, enter interfaces, followed by the slot number,

a slash (/), the first combo port number, a hyphen (-), the last combo port number, hybrid, either fiber or

copper, crossover, and the desired setting. For example, to set the crossover configuration to auto on

copper combo ports 45 through 48 on slot 2, enter:

-> interfaces 2/45-48 hybrid copper crossover auto

As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet

before the slot number. For example, to set the crossover configuration to auto on copper combo port 47

on slot 2 and document the combo port as Gigabit Ethernet, enter:

-> interfaces gigaethernet hybrid copper 2/3 crossover auto

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 701 702

Comentarios a estos manuales

Sin comentarios

Alcatel 9000 Guía de usuario Pagina 59

Comentarios a estos manuales

Relacionado con productos y manuales para Software Alcatel 9000