Alcatel 9000 Guía de usuario descargar pdf (Pagina 256)

100

101

Modifying Static Aggregation Group Parameters Configuring Static Link Aggregation

page 13-10 OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006

Modifying Static Aggregation Group Parameters

This section describes how to modify the following static aggregate group parameters:

• Static aggregate group name (see “Modifying the Static Aggregate Group Name” on page 13-10)

• Static aggregate group administrative state (see “Modifying the Static Aggregate Group Administra-

tive State” on page 13-10)

Modifying the Static Aggregate Group Name

The following subsections describe how to modify the name of the static aggregate group with the static

linkagg name command.

Creating a Static Aggregate Group Name

To create a name for a static aggregate group by entering static linkagg followed by the number of the

static aggregate group, name, and the user-specified name of the group, which can be up to 255 characters

long. For example, to configure static aggregate group 4 with the name “Finance” you would enter:

-> static linkagg 4 name Finance

Note. If you want to specify spaces within a name for a static aggregate group the name must be specified

within quotes (e.g., “Static Aggregate Group 4”).

Deleting a Static Aggregate Group Name

To remove a name from a static aggregate group you use the no form of the static linkagg name

command by entering static linkagg followed by the number of the static aggregate group and no name.

For example, to remove any user-specified name from static aggregate group 4 you would enter:

-> static linkagg 4 no name

Modifying the Static Aggregate Group Administrative State

By default, the administrative state for a static aggregate group is enabled. The following subsections

describe how to enable and disable the administrative state with the static linkagg admin state command.

Enabling the Static Aggregate Group Administrative State

To enable a static aggregate group by entering static linkagg followed by the number of the group and

admin state enable. For example, to enable static aggregate group 1 you would enter:

-> static linkagg 1 admin state enable

Disabling the Static Aggregate Group Administrative State

To disable a static aggregate group by entering static linkagg followed by the number of the group and

admin state disable. For example, to disable static aggregate group 1 you would enter:

-> static linkagg 1 admin state disable

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 701 702

Comentarios a estos manuales

Sin comentarios

Alcatel 9000 Guía de usuario Pagina 256

Comentarios a estos manuales

Relacionado con productos y manuales para Software Alcatel 9000