Alcatel 9000 Guía de usuario descargar pdf (Pagina 271)

100

101

Configuring Dynamic Link Aggregation Configuring Dynamic Link Aggregate Groups

OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006 page 14-13

As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port

number to document the interface type or make the command look consistent with early-generation Alca-

tel CLI syntax. For example, to configure an actor administrative key of 10 and to document that the port

is a 10-Mbps Ethernet port to slot 4 port 1, enter:

-> lacp agg ethernet 4/1 actor admin key 10

Note. The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See

Chapter 1, “Configuring Ethernet Ports,” for information on configuring Ethernet ports.

Removing Ports from a Dynamic Aggregate Group

To remove a port from a dynamic aggregate group, use the no form of the lacp agg actor admin key

command by entering lacp agg no followed by the slot number, a slash (/), and the port number.

For example, to remove port 4 in slot 4 from any dynamic aggregate group you would enter:

-> lacp agg no 4/4

Ports must be deleted in the reverse order in which they were configured. For example, if port 9 through

16 were configured to join dynamic aggregate group 2 you must first delete port 16, then port 15, and so

forth. The following is an example of how to delete ports in the proper sequence from the console:

-> lacp agg no 4/24

-> lacp agg no 4/23

-> lacp agg no 4/22

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 701 702

Comentarios a estos manuales

Sin comentarios

Alcatel 9000 Guía de usuario Pagina 271

Comentarios a estos manuales

Relacionado con productos y manuales para Software Alcatel 9000