Alcatel 9000 Guía de usuario descargar pdf (Pagina 53)

100

101

Configuring Ethernet Ports Setting Ethernet Parameters for Non Combo Ports

OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006 page 1-17

As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet

before the slot number. For example, to enable autonegotiation on port 3 on slot 2 and document the port

as Ethernet, enter:

-> interfaces ethernet 2/3 autoneg enable

Note. Please refer to “Autonegotiation Guidelines” on page 1-7 for guidelines on configuring autonegotia-

tion.

Configuring Crossover Settings

To configure crossover settings on a single port, a range of ports, or an entire slot use the

interfaces crossover command. If autonegotiation is disabled, auto MDIX, auto speed, and auto duplex

are not accepted.

Setting the crossover configuration to auto will configure the interface or interfaces to automatically

detect crossover settings. Setting crossover configuration to mdix will configure the interface or inter-

faces for MDIX (Media Dependent Interface with Crossover), which is the standard for hubs and switches.

Setting crossover to mdi will configure the interface or interfaces for MDI (Media Dependent Interface),

which is the standard for end stations. And setting the crossover configuration to disable will disable

crossover configuration on an interface or interfaces.

To configure crossover settings on an entire switch, enter interfaces, followed by the slot number, cross-

over, and the desired setting. For example, to set the crossover configuration to auto on slot 2, enter:

-> interfaces 2 crossover auto

To configure crossover settings on a single port, enter interfaces, followed by the slot number, a slash (/),

the port number, crossover, and the desired setting. For example, to set the crossover configuration to auto

on port 3 on slot 2, enter:

-> interfaces 2/3 crossover auto

To configure crossover settings on a range of ports, enter interfaces, followed by the slot number, a slash

(/), the first port number, a hyphen (-), the last port number, crossover, and the desired setting. For exam-

ple, to set the crossover configuration to auto on ports 1 through 3 on slot 2, enter:

-> interfaces 2/1-3 crossover auto

As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet

before the slot number. For example, to set the crossover configuration to auto on port 3 on slot 2 and

document the port as Gigabit Ethernet, enter:

-> interfaces gigaethernet 2/3 crossover auto

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 701 702

Comentarios a estos manuales

Sin comentarios

Alcatel 9000 Guía de usuario Pagina 53

Comentarios a estos manuales

Relacionado con productos y manuales para Software Alcatel 9000