Alcatel 9000 Guía de usuario descargar pdf (Pagina 48)

100

101

Setting Ethernet Parameters for All Port Types Configuring Ethernet Ports

page 1-12 OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006

By default the following peak flood rate values are used for limiting the rate at which traffic is flooded on

a switch port:

To change the peak flood rate for an entire slot, enter interfaces followed by the slot number, flood rate,

and the flood rate in megabits. For example, to configure the peak flood rate on slot 2 as 49 megabits,

enter:

-> interfaces 2 flood rate 49

To change the peak flood rate for a single port, enter interfaces followed by the slot number, a slash (/),

the port number, flood rate, and the flood rate in megabits. For example, to configure the peak flood rate

on port 3 on slot 2 as 49 megabits, enter:

-> interfaces 2/3 flood rate 49

To change the peak flood rate for a range of ports, enter interfaces followed by the slot number, a slash (/

), the first port number, a hyphen (-), the last port number, flood rate, and the flood rate in megabits. For

example, to configure the peak flood rate on ports 1 through 3 on slot 2 as 49 megabits, enter:

-> interfaces 2/1-3 flood rate 42

As an option, you can document the interface type by entering ethernet, fastethernet, or gigaethernet

before the slot number. For example, to configure the peak flood rate on port 22 on slot 2 as 49 megabits

and document the port as Gigabit Ethernet, enter:

-> interfaces gigaethernet 2/22 flood rate 49

To specify the type of traffic elligible for rate limiting, see “Flood Only Rate Limiting” on page 1-10 and

“Multicast Flood Rate Limiting” on page 1-11 for more information.

Configuring a Port Alias

The interfaces alias command is used to configure an alias (i.e., description) for a single port. (You

cannot configure an entire switch or a range of ports.) To use this command, enter interfaces followed by

the slot number, a slash (/), the port number, alias, and the text description, which can be up to 40 charac-

ters long.

For example, to configure an alias of “ip_phone1” for port 3 on slot 2 enter:

-> interfaces 2/3 alias ip_phone1

Note. Spaces must be contained within quotes (e.g., “IP Phone 1”).

parameter default

Mbps (10 Ethernet) 4

Mbps (100 Fast Ethernet) 49

Mbps (Gigabit Ethernet) 496

Mbps (10 Gigabit Ethernet) 997

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 701 702

Comentarios a estos manuales

Sin comentarios

Alcatel 9000 Guía de usuario Pagina 48

Comentarios a estos manuales

Relacionado con productos y manuales para Software Alcatel 9000