Alcatel 9000 Guía de usuario descargar pdf (Pagina 146)

100

101

Configuring STP Port Parameters Configuring Spanning Tree Parameters

page 6-30 OmniSwitch 6800/6850/9000 Network Configuration Guide June 2006

available when the switch is running in either mode (1x1 or flat) and an instance number is not required.

For example, the following commands configure the connection type for port 1/24 for the flat mode

instance:

-> bridge 1/24 connection ptp

-> bridge cist 1/24 connection ptp

As in previous releases, it is possible to configure the flat mode instance with the bridge slot/port connec-

tion command by specifying 1 as the instance number (e.g., bridge 1 1/24 connection noptp). However,

this is only available when the switch is already running in the flat mode and STP or RSTP is the active

protocol.

Note that the bridge slot/port connection command only configures one port at a time.

Connection Type on Link Aggregate Ports

Physical ports that belong to a link aggregate do not participate in the Spanning Tree Algorithm. Instead,

the algorithm is applied to the aggregate logical link (virtual port) that represents a collection of physical

ports. To change the port connection type for a link aggregate, use the bridge slot/port connection

commands described above, but specify a link aggregate control number instead of a slot and port. For

example, the following command defines the link aggregate 10 associated with VLAN 755 as an edge

port:

-> bridge 755 10 connection edgeport

For more information about configuring an aggregate of ports, see Chapter 13, “Configuring Static Link

Aggregation,” and Chapter 14, “Configuring Dynamic Link Aggregation.”

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 701 702

Comentarios a estos manuales

Sin comentarios

Alcatel 9000 Guía de usuario Pagina 146

Comentarios a estos manuales

Relacionado con productos y manuales para Software Alcatel 9000