Alcatel OmniSwitch/Router Guía de usuario descargar pdf (Pagina 42)

Loading Software onto the Switch Managing System Files

page 1-22 OmniSwitch 6250/6450 Switch Management Guide May 2012

1 Establish a connection to the switch as explained in your appropriate Getting Started Guide.

2 Log on to the switch and enter the ftp command to start the FTP client. Next, enter a valid host name or

IP address. (For information about enabling the DNS resolver for host names, please refer to Chapter 2,

“Logging Into the Switch.”) A screen similar to the following is displayed:

-> ftp 198.23.9.101

Connecting to [198.23.9.101]...connected

220 cosmo FTP server (UNIX(r) System V Release 4.1) ready

Name :

Note. You can only use a host name instead of an IP address if the DNS resolver has been configured and

enabled. If not, you must specify an IP address.

You can use the ftp6 command followed by the IPv6 address or the hostname of the FTPv6 server to start

an FTPv6 session over an IPv6 environment. For example:

-> ftp6 fe80::a00:20ff:fea8:8961 intf1

Connecting to [fe80::a00:20ff:fea8:8961]...connected

220 cosmo FTP server (UNIX(r) System V Release 4.1) ready

Name :

Note. FTPv6 sessions are supported only on the OmniSwitch 6250. It is mandatory to specify the name of

the particular IPv6 interface, if the FTPv6 server has been specified using its link-local address.

3 Set the client to binary mode with the bin command. Enter a valid user name and password for the host

you specified with the ftp command. A screen similar to the following is displayed:

Name: Jsmith

331 Password required for Jsmith

Password: *****

230 User Jsmith logged in.

4 After logging in, you will receive the ftp-> prompt. You may enter a question mark (?) to view

available FTP commands as shown here.

ftp->?

Supported commands:

ascii binary bye cd delete

dir get help hash ls

put pwd quit remotehelp user

lpwd mput mget prompt !ls

lcd user

These are industry standard FTP commands. Their definitions are given in the following table:

ascii Set transfer type to ASCII (7-bit).

binary Set transfer type to binary (8-bit).

bye Close session gracefully.

cd Change to a new directory on the remote machine.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 345 346

Sin comentarios

Alcatel OmniSwitch/Router Guía de usuario Pagina 42