Alcatel OmniSwitch/Router Guía de usuario descargar pdf (Pagina 202)

Creating Snapshot Configuration Files Working With Configuration Files

page 7-10 OmniSwitch 6250/6450 Switch Management Guide May 2012

Creating Snapshot Configuration Files

You can generate a list of configurations currently running on the switch by using the configuration

snapshot command. A snapshot is a text file that lists commands issued to the switch during the current

Note. A user must have read and write permission for the configuration family of commands to generate a

snapshot file for those commands. See the “Switch Security” chapter of this manual for further informa-

tion on permissions to specific command families.

Snapshot Feature List

You can specify the snapshot file so that it will capture the CLI commands for one or more switch features

or for all network features. To generate a snapshot file for all network features, use the following syntax:

-> configuration snapshot all

To generate a snapshot file for specific features, select the appropriate syntax from the following list.

You may enter more than one network feature in the command line. Separate each feature with a space

(and no comma). The following command will generate a snapshot file listing current configurations for

the vlan, qos, and snmp command families.

-> configuration snapshot vlan qos snmp

You can verify that a new snapshot file is created by using the ls command to list all files in the /flash

directory.

Snapshot Keywords

802.1Q ipmr rip

aaa ip-helper ripng

aip interface rdp

all ip-routing session

bridge linkagg snmp

chassis module stp

health ntp system

ip pmm vlan

ipms policy webmgt

ipv6 qos

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 345 346

Sin comentarios

Alcatel OmniSwitch/Router Guía de usuario Pagina 202