Alcatel OmniSwitch/Router Guía de usuario descargar pdf (Pagina 287)

Using WebView WebView CLI Commands

OmniSwitch 6250/6450 Switch Management Guide May 2012 page 11-3

WebView CLI Commands

The following configuration options can be performed using the CLI. These configuration options are also

available in WebView; but changing the web server port or secured port can only be done through the CLI

(or SNMP).

Enabling/Disabling WebView

WebView is enabled on the switch by default. If necessary, use the http server command to enable

WebView. For example:

-> http server

Use the no http server command to disable WebView on the switch. If web management is disabled, you

will be unable to access the switch using WebView. Use the show http command to view WebView

status.

As an alternative you can use the https keyword instead of the http keyword to enable WebView. For

example:

-> https server

When using this format of the command use the no https server command to disable WebView on the

switch.

Changing the HTTP Port

The default HTTP port is 80, the well-known port number for Web servers. You can change the port to a

number in the range 0 to 65535 using the http port command. (Well-known port numbers, which are in

the range 0 to 1023, cannot be configured.)

Note. All WebView sessions must be terminated before the switch accepts the command.

For example:

-> http port 2000

This command changes the HTTP port to 2000.

To restore an HTTP port to its default value, use the default keyword as shown in the following example:

-> http port default

1 2 ... 282 283 284 285 286 287 288 289 290 291 292 ... 345 346

Sin comentarios

Alcatel OmniSwitch/Router Guía de usuario Pagina 287