Alcatel OS6400-24 Guía de usuario descargar pdf (Pagina 69)

Mounting OS6400 Switches Installing Power Supplies

OmniSwitch 6400 Series Hardware Users Guide July 2010 page 3-13

Installing Power Supplies

OmniSwitch 6400 Series power supply can be installed in the following ways:

• As a primary or backup supply directly connected to the back of an OmniSwitch 6400 Series chassis.

See “Connecting a Power Supply to the Chassis” below for more information.

• As a primary or backup supply rack mounted directly above or below the switch and connected with a

cable. See “Connecting Chassis to Power Source” on page 3-19 for more information.

DC power supplies require additional installation steps. See “DC Power Specifications” on page 2-29 for

more information.

Anti-Static Warning. Before handling any components, free yourself of static by wearing a grounding

strap, or by grounding yourself properly. Static discharge can damage the switch and the backup power

supply.

Connecting a Power Supply to the Chassis

Follow the steps below to connect a power supply directly (i.e., without a cable) to the rear of an

OmniSwitch 6400 Series chassis.

Note. For information on rack mounting power supplies and connecting the power supply via a connector

cable, refer to “Rack Mounting Power Supplies” on page 3-15.

1 Place the chassis, power supply, and shelf on a smooth, clean, and dry surface.

2 Carefully slide the power shelf so that it is flush against the back of the chassis.

3 Tighten the two captive screws located on the left and right sides of the power shelf.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 151 152

Sin comentarios

Alcatel OS6400-24 Guía de usuario Pagina 69