Alcatel OS6400-24 Guía de usuario descargar pdf (Pagina 67)

Mounting OS6400 Switches Setting Up a Stacked Configuration

OmniSwitch 6400 Series Hardware Users Guide July 2010 page 3-11

Cabling Steps

1 Before inserting a stacking cable into one of the stacking, be sure to orient the stacking cable connec-

tor properly. The wide portion of the connector must be facing up. Refer to the diagram below for more

information.

End View of Stacking Cable Connector

2 Starting from the top of the stack, insert one end of the stacking cable into either stacking port A or

stacking port B. The stacking port (A or B) depends on your preferred cabling pattern. Be sure that cable

connector is completely inserted and fully seated in the chassis.

3 Insert the other end of the stacking cable into the stacking port of the switch immediately below. Once

again, the stacking port (A or B) depends on the preferred cabling pattern.

4 Repeat this procedure until all switches in the stack are connected (see illustrations a, b, and c below).

Reminder. The diagram below shows one supported stacking cable pattern. For additional supported

cabling patterns, refer to Chapter 6, “Managing OmniSwitch 6400 Series Stacks.”

Connecting the Switches in the Stack

Connector Top

When orienting the stacking cable connector, be sure

that the wider portion of the connector is facing up as

shown. Otherwise, the stacking cable will not fit

properly in the chassis’ stacking port.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 151 152

Sin comentarios

Alcatel OS6400-24 Guía de usuario Pagina 67