Alcatel OmniPCX Enterprise R7.1 Manual de instalación descargar pdf (Pagina 29)

Each category-5 RJ45 connector has 2 green LEDs:

- Left LED = link status and activity:

• off: link disconnected

• on: link connected

• blinking: link active

- Right LED = full duplex/collision:

• off: Half Duplex

• on: Full Duplex

• blinking: collision

2.4.1.12 LANX-2 Boards

The LanX8-2 and LanX16-2 are second generation boards integrating respectively 1 or 2

Ethernet Gigabit ports for a Lanswitch/Layer 2 configuration. Any port can be used as an

Uplink, as all the ports are auto MDI/MDIX.

Unlike the 1st generation boards, the LEDs of the A and B ports are both located at the top of

the board. The Led display is as follows:

- Green LED (left) = link status and activity:

• off: link disconnected

• on: link connected

• blinking: link active

- yellow LED (right) = speed:

• off: low speed (10 or 100 Mb for Gigabit port, 10 Mb for the other ports)

• on: high speed (1 Gb for Gigabit port, 100 Mb for the other ports)

&#' $(  #( #

        

2-15

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 191 192

Sin comentarios

Alcatel OmniPCX Enterprise R7.1 Manual de instalación Pagina 29