Alcatel 1000 ADSL Especificaciones descargar pdf (Pagina 13)

Capac: Displays the capacity of the line. This is the ratio of

achieved bit rate (B/Rate or IntB/R) over the maximum attain-

able bit rate. Results are presented as a percentage (%).The

value for capacity should be reasonably high (greater than

90%). A low value could mean that there is noise on the line.

IntB/R: Displays the achieved interleaved bit rate. Results are

presented in kbits/s. The measured values for upstream and

downstream should be greater than minimum bit rate set in the

ATU-C. The result will be 0 if Fast Bit Rate is turned on in the

ATU -C.

NseM: Displays the realized noise margin. This is the amount of

increased noise relative to the measured noise power that the

system would be able to tolerate to maintain a bit error rate of

-7 . Results are presented in dB. The industry standard is for

a minimum value of 6 dB.

Power: Displays the aggregate power which is a measure of

total output power. Results are presented in dBm.

Atten: Displays the total attenuation. The attenuation is the

measured difference in dB between the power transmitted at

the near end and received at the far end.

Op.Mode: Displays the negotiated Operating Mode between

the ATU-C and the TS1000. Results can be either ANSI,

G.DMT or G.LITE.

If the Op. Mode: is ANSDI:

Vendor ID: Displays the manufacturer information of the ATU-C

called Vendor ID. This result will only appear if the manufac-

turer’s ATU-C supports this feature. For example, “Vendor ID:

0022” indicates Alcatel Network Systems, Inc.

If the Op.Mode: is GDMT or G.LITE:

Prov: Displays the ITU Provider Code (Vendor ID). This result

will only appear if the manufacturer’s ATU-C supports this fea-

ture.

Spec.Info: Displays the ITU Vendor Specific Information. This

result will only appear if the manufacturer’s ATU-C supports this

feature.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Alcatel 1000 ADSL Especificaciones Pagina 13