Alcatel OmniPCX Enterprise R7.1 Manual de usuario descargar pdf (Pagina 89)

OmniPCX Enterprise

INSTALLATION PROCEDURE FOR VERSION

J1.410.34.c – RELEASE 10.0

APPENDIX 2

REMARKS & RESTRICTIONS

Ed. 02 / 22 June 2011 17 TC1449

− For a GDx/GAx/INTIPx, the number of trunks in a trunk group must not be managed. You must

retain the default configuration (30 trunks created). The limitation of compressors will be carried

out by managing the VPN TS % in the trunk group or by the "VPN Call Limitation" feature.

− From R5.0 Lx, QoS profile control on ABC-F VoIP links is no longer available (with/out direct RTP

switching in network).

− The VoIPstat command is no longer usable.

− Mix of communication with Fax and Voice in a same room: during the voice communication, the

DSP might change to Fax mode; the only workaround is to reduce the volume of the Fax.

− As of Release 9.1, the boolean H323 signaling for inter-node links has been

removed: only the H323 mode is possible. The other nodes of the ABC-F network must be

managed accordingly. NGP boards only support this mode.

− When creating or modifying the IP trunk group on a GD, the Media Gateway will reset in order

to take into account the changes.

− UDP port range: UDP base port manageable by a system parameter and taken into account by

all IP equipments (Call Server, INTIP, GD, GA, IP Phone, etc.) except Fast IP Enabler.

CAUTION

This parameter is common for all the installation and is managed only under

IP/IP Phones Parameters/UDP Port

− QoS Tickets.

• QoS tickets are provided by GD/GA/INTIP boards, IP Phone V2, IP Touch (in NOE mode), My

Phone and 4645 voice mail.

− Fax over IP.

• The rate is limited to 9600 bit/s in Fax Relay mode with common hardware and Crystal

Hardware.

• The rate remains at 9600 bit/s for the inter Media-Gateway T38 fax mode, introduced in

R9.0.

• Fax T38 interworking with OmniAccess 512 (VSA Interface) is not available.

• Fax V34 is supported.

• From Release 7.0, the Analog type parameter used to create an analog equipment of

"Fax" or "Modem" type in order to initialize the connection in transparent mode from the start

of the communication , concern only the modem:

Users / Analog type + No specific management or Fax

• If the equipment is a fax: Switch-over to transparency after detection of 2100 Hz by DSP.

• If the equipment is a modem: Switch-over to transparency after detection of 2100 Hz par le

DSP,

If there is no carrier, no switch-over to transparency.

• If the equipment is a set: No switch-over to transparency except if the DSP detects the 2100

Hz.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 107 108

Comentarios a estos manuales

Sin comentarios

Alcatel OmniPCX Enterprise R7.1 Manual de usuario Pagina 89

Comentarios a estos manuales

Relacionado con productos y manuales para Servidores Alcatel OmniPCX Enterprise R7.1